There are two necessary parts for the RoadGear to run on battery power: BP-RG RoadGear Battery Pack CV-RG DC-DC Power Converter  Under normal operating conditions with average power consumption the battery pack provides 3-4 hours of continuous operation. However, if the built-in power amplifier... more

The Powerpod K-12, K-16 and 1860 Deluxe all featured what are referred to as combo jacks. These jacks are able to accept both XLR microphone inputs and 1/4 phone jacks. Note: Powerpod K-12, Powerpod K-16 and Powerpod 1860 Deluxe have been discontinued and replaced by Powerpod K-12 Plus, Powerpod K-16 Plus and... more

When connecting 4 speakers to the RoadGear, the total loading for each power amplifier channel should not be lower than 4 ohms. Therefore, the impedance of each speaker should be 8 ohms or greater. The two RoadGear speakers can be used in this case, as well as 2 other 8 ohm speakers. As for sound quality, of course... more

Q: Is it possible to run a send and return on the AUX channel so that all channels are affected by the effect? Can I use a chaos pad to affect the main out channels by coming out the control room channel, through the chaos pad and back into the mixer through regular channels? A: There's no reason why you... more

Follow the instructions below to hear individual input channels through your headphones or control room monitors. Depending on your model, however, these steps may vary slightly. Set the EFX send and channel level controls to an appropriate level. Press the EFX CUE button (located above the CTRL RM volume... more

Q: Will the adjustments I make on the Powerpod K-12s main EQ be applied to the mono output? A: Yes, when the graphic EQ is turned on and MAIN is selected, then the frequency changes also affect the mono output.  more

As the Powerpod 408 only has one power amplifier, there is no difference between connecting the speakers individually or both to one output. In essence, connecting two speakers individually is the same as connecting two speakers in parallel. However it should be noted that users should not connect one speaker to... more

Q: The manual for my mixer advises that disconnecting the ring-pin will prevent damage to the mixer from sending unbalanced signals from the main outputs. How do I do this? A: Since the publication of the manual, we've ensured that using an unbalanced cable with those particular connections will ensure not... more

Q: How would I hook up a processor to my MU/AM mixer so that it allows me to get just the processed sound and not the original? A: You would plug the EFX send from the mixer into the input of your effects unit and the output of the effects unit into the effects return on the mixer. To get only the effected... more

The Studio Wizard needs to be plugged in and turned on for any of the routing to occur.